How can the hierarchy of controls reduce hand-arm vibration exposure and HAVS risk?

Redesign the task and choose lower-vibration methods before using trigger-time limits and surveillance to manage residual exposure.

Verify controls: Grinding welds on steel components

Verify controls: Grinding welds on steel components. A task-specific verification map alongside the existing hierarchy diagrams. These checks retain the assessed task, failure and release boundary; they are not a separate permit system.
Learning point: A task-specific verification map alongside the existing hierarchy diagrams. These checks retain the assessed task, failure and release boundary; they are not a separate permit system.
Read the complete visual as text
  1. Actual task: A fabricator removes excess weld material with a hand-held grinder; assess vibration alongside wheel, dust, noise and fire hazards.
  2. Evidence to check: tool/accessory condition, representative vibration, trigger time and workholding
  3. Stop or hold condition: abnormal vibration, defective consumable, uncontrolled exposure or reported symptoms requiring review
  4. Release evidence and owner: supervisor accepts a maintained tool and achievable exposure controls

Verify controls: Breaking out a concrete pad

Verify controls: Breaking out a concrete pad. A task-specific verification map alongside the existing hierarchy diagrams. These checks retain the assessed task, failure and release boundary; they are not a separate permit system.
Learning point: A task-specific verification map alongside the existing hierarchy diagrams. These checks retain the assessed task, failure and release boundary; they are not a separate permit system.
Read the complete visual as text
  1. Actual task: A crew proposes hand-held breaking of identified concrete; assess vibration, silica, noise, services and debris.
  2. Evidence to check: concrete identity, services, tool condition, dust control and realistic vibration exposure
  3. Stop or hold condition: unexpected service/reinforcement, failed dust control or exposure outside the assessed plan
  4. Release evidence and owner: supervisor accepts the revised safe method before further breakout

A warm glove or a short briefing cannot compensate for a poorly chosen breaker. First ask whether the hole, cut or surface finish can be designed or made off site, machine-mounted, or completed by a suitable lower-vibration method. Then check tool condition, accessories, real-use vibration data and the combined daily exposure. Job rotation only works if each person’s total is reduced; spreading the same hazardous task among more workers is not an elimination strategy.

ERICPD is a control-planning mnemonic used on this page, not a regulation. HSE’s hierarchy gives priority to elimination, substitution and engineering over administrative limits and personal protection. “Discipline” here means reliable instruction, observation and action on reports, not blame.

Where risk remains, a planned programme should name the tool, maximum assessed use for the job, maintainer, supervisor check and a route for symptoms. Exposure below an action value is not a guarantee against injury. HSE control guidance.